Heating repair
Heating and furnace repair in San Antonio.
When the first real cold front comes through and the heat won’t start, Tom finds the fault and fixes what needs fixing.
Quick answer
TG AC & Heating repairs furnaces, heat pumps, and electric heating systems for homes and businesses across greater San Antonio. Owner Tom Goodwin has worked in HVAC since 1998 and is licensed in Texas. The phone consultation is free, there is no callout fee when we do the work, and we beat any verified written quote by $10. Call (210) 687-7376. If you smell gas, leave the house first and call your gas utility or 911 from outside.
Signs your heating system needs a repair
- The fan runs but the air is cold.
- The furnace starts, runs for a minute, and shuts off. It may try this several times before locking out.
- Nothing happens when the thermostat calls for heat.
- The breaker trips when the heat comes on. Common with electric heat strips.
- Some rooms heat and others don’t, or the system runs constantly on a cold night and falls behind.
- The outdoor unit of a heat pump is a solid block of ice. Light frost that clears itself is normal. A unit encased in ice is not.
- Banging, squealing, or rumbling at startup.
What goes wrong, by system type
Gas furnaces
Most no-heat calls on a gas furnace come down to a short list: a cracked or worn-out hot surface ignitor, a flame sensor coated with residue so the furnace can’t prove it has lit, a pressure switch or inducer motor fault, or a high-limit switch that opens because the furnace is overheating behind a clogged filter. A good tech also looks at the burners and the heat exchanger while the cabinet is open.
Heat pumps
A heat pump is an air conditioner that can run in reverse, so anything that stops it cooling can stop it heating: a bad capacitor or contactor, a low refrigerant charge, a failed fan motor. Problems specific to heating are a reversing valve that sticks, a defrost control that doesn’t clear ice off the outdoor coil, and auxiliary heat strips that have failed, which you only notice on the coldest nights. More on our heat pump page.
Electric furnaces and air handlers
All-electric homes heat with resistance elements in the air handler. The elements, their sequencers, and their safety limits are the usual failures, along with the blower motor.
A short heating season is hard on equipment
San Antonio winters are mild, with freezes arriving in short bursts behind cold fronts. That means a furnace here can sit idle for eight or nine months and then get asked to run hard on one night’s notice. Dust settles on burners and sensors. Ignitors that were marginal last February fail on the first call this year. And as the February 2021 winter storm showed, a hard freeze here is rare but not impossible.
The cheap way to avoid a no-heat night is to run the heat for ten minutes in October, change the filter, and have the system looked at before it is needed. A winter visit on our 35-point tune-up is $125 per unit.
Gas and carbon monoxide: when not to wait
- You smell gas. Leave the building, then call your gas utility’s emergency number or 911 from outside.
- A carbon monoxide alarm sounds. Get everyone out into fresh air and call 911. Don’t go back in to open windows.
- Soot around the furnace, or a burner flame that is yellow and lazy instead of steady blue. Shut the furnace off and have it checked before using it again.
Any home with a gas furnace, gas water heater, or attached garage should have working carbon monoxide alarms.
What to check before you call
- Thermostat set to Heat, with a set temperature above the room temperature. Replace the batteries if it has them.
- A clean filter. A clogged one is the most common cause of a furnace that starts and then shuts down.
- Breakers for both the furnace or air handler and, on a heat pump, the outdoor unit.
- The service switch near the furnace, which looks like a light switch and gets turned off by accident.
Still cold? Call (210) 687-7376 or send a repair request. If the system is old enough that you are weighing replacement, Tom will give you the repair price and his honest read on the equipment. We also do new installs and replacements.
Heating repair questions
- Why is my heater blowing cold air?
- On a gas furnace, the usual causes are a failed ignitor, a dirty flame sensor, or a safety limit that tripped because a clogged filter let the furnace overheat. On a heat pump, cool air for a few minutes can be a normal defrost cycle. If it lasts, the cause may be a low refrigerant charge, a stuck reversing valve, or failed backup heat strips. Check the thermostat mode and the filter first.
- Is a burning smell normal when I first turn on the heat?
- A dusty, burning smell for the first hour of the season is usually dust burning off the heat exchanger or the electric heat strips, and it clears on its own. A smell that persists, smells like melting plastic or electrical burning, or comes with smoke is not normal. Shut the system off and call.
- What should I do if I smell gas?
- Leave the building right away. Don’t use light switches, phones, or anything that could spark while you are inside. Once you are outside and away from the house, call your gas utility’s emergency line or 911. Call an HVAC contractor only after the utility says it is safe.
- How much does furnace repair cost?
- It depends on the part. We don’t publish a guess. The phone consultation is free, the callout fee is waived when we do the work, and we beat any verified written quote for the same repair by $10.
- Do I really need a heating check in San Antonio?
- The heating season here is short, which is the reason to check it: the furnace sits unused for most of the year and gets found out on the first cold night. A winter tune-up is $125 per unit, or $200 per unit paired with a summer visit.
- Do you repair heat pumps as well as furnaces?
- Yes. We repair and install both. A heat pump heats and cools with the same equipment, so a heating problem on one is often the same fault that would show up in summer.
“Tom was friendly and fair. Grateful for his quick response! He did a great job explaining what he was working on, and what he thought we should do next.”
Related reading
- Heat pump or AC and furnace?
Which makes sense for a San Antonio house.
- How often should a system be serviced?
Why a fall visit matters if the same system heats.
- Heat pump installation & repair
One system for heating and cooling.
Other services
Where we do this work
Heating & furnace repair across greater San Antonio, including San Antonio, Schertz, New Braunfels, Cibolo, Converse, Boerne.
Full service areaHeat not working?
Call Tom directly or send a request. Free phone consultation, no callout fee when we do the work, and we beat any verified quote by $10.